GW Instek GDM-8342 - Page 25

GETTING STARTED
25
Power Up
Steps
1. Ensure the correct line
voltage is lined up with
the arrow on the fuse
holder. If not, see page 145
to set the line voltage and
fuse.
2. Connect the power
cord to the AC
voltage input.
Note
Make sure the ground connector on the power
cord is connected to a safety ground. This will
influence the measurement accuracy.
3. Push to turn on the
main power switch
on the front panel.
P
O
WE
R
4. The display turns on and shows the last
function that was used before the power was
reset.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com