GW Instek GDS-1000A-U Series - Page 101

CONFIGURATION
101
4. Press Mode repeatedly to
select the trigger mode,
Auto or Normal. To select
the Single trigger mode,
press the Single key.
Mode
Auto
SINGLE
Range
Auto, Normal
5. Press When repeatedly to
select the pulse condition.
Then use the Variable knob
to set the pulse width.
When <
20.0ns
VARIABLE
Condition
> , < , = , ≠
Width
20ns ~ 10s
6. Press Slope/Coupling to set
trigger slope and coupling.
Slope /
Coupling
7. Press Slope repeatedly to
select the trigger slope,
which also appears at the
bottom of the display.
Slope
Range
Rising edge, falling edge
8. Press Coupling repeatedly to
select the trigger coupling.
Coupling
AC
Range
DC, AC
9. Press Rejection to select the
frequency rejection mode.
Rejection
Off
Range
LF, HF, Off