GW Instek GDS-1000A-U Series - Using the Vertical Cursors

MEASUREMENT
61
M1:dB
Position of the left cursor in dB.
M2:dB
Position of the right cursor in dB.
∆: dB
The dB difference between M1 and M2.
Div:
The frequency per division.
Moving the
horizontal
cursors
To move the left cursor, press
X1 and then use the Variable
knob.
X1
-5.000uS
0.000uV
To move the right cursor, press
X2 and then use the Variable
knob.
X2
5.000uS
0.000uV
To move both cursors at once,
press X1X2 and then use the
Variable knob.
X1X2
10.00uS
100.0kHz
0.000uV
∆ :
f :
Remove cursors
Press Cursor to remove the
onscreen cursors.
Cursor
Using the vertical cursors
Procedure
1. Press the Cursor key.
Cursor
2. Press X ↔ Y to select the
vertical (Y1&Y2) cursor.
X↔Y
3. Press Source repeatedly to
select the source channel.
Source
CH1
Range
CH1, 2, MATH
4. The cursor measurement results will appear in
the menu.
Parameters
Y1
Voltage level of the upper cursor
Y2
Voltage level of the lower cursor