GW Instek GDS-1000A-U Series - Cursor Measurements; Using the Horizontal Cursors

GDS-1000A-U Series User Manual
60
Cursor Measurements
Cursor lines, horizontal or vertical, show the precise position of the
input waveforms or the math operation results. The horizontal
cursors can track time, voltage/current* and frequency, whilst the
vertical cursors can track voltage/current*. All measurements are
updated in real-time. *probe type dependant (page 93).
Using the horizontal cursors
Procedure
1. Press the Cursor key. The
cursors appear in the
display.
Cursor
2. Press X ↔ Y to select the
horizontal (X1&X2) cursor.
X↔Y
3. Press Source repeatedly to
select the source channel.
Source
CH1
Range
CH1, 2, MATH
4. The cursor measurement results will appear in
the menu, F2 to F4.
Parameters
X1
Time position of the left cursor. (relative to
zero)
X2
Time position of the right cursor. (relative
to zero)
X1X2
The difference between the X1 and X2.
∆: us
The time difference between X1 and X2.
f: Hz
The time difference converted to
frequency.
V/A
The voltage/current difference from X1
and X2.