FAQ
193
FAQ
I connected the signal but it does not appear on the display.
I want to remove the (Measurement result / FFT result / Help
contents) from the display.
The waveform does not update (frozen).
The probe waveform is distorted.
Autoset does not catch the signal well.
I can’t save files to the internal memory.
The display image printout is too dark on the background.
The date and time setting are not correct.
The accuracy does not match the specification.
When trying to perform Vertical Accuracy Calibration, error messages
always appear.
I connected the signal but it does not appear on the display.
Make sure you have activated the channel by pressing the Channel
key (the channel key lights up).
To Next Page
Loading...
