GW Instek GDS-3000 Series - Page 198

GDS-3000 Series User Manual
198
I
2
C (optional):Trigger on Start, Repeated Start,
Stop, Missing ACK, Address (7 or 10 bit), Data, or
Address and Data on I
2
C buses.
UART (optional):
Trigger on Tx Start Bit, Rx Start Bit, Tx End of
Packet, Rx End of Packet, Tx Data, Rx Data, Tx
Parity Error, and Rx Parity Error.
Holdoff range
10ns to 10s
Coupling
AC, DC, LF rej., Hf rej., Noise rej.
Sensitivity
GDS-31XX ~ GDS-33XX:
DC ~ 50MHz Approx. 1div or 10mV
50MHz ~ 150MHz Approx. 1.5div or 15mV
150MHz ~ 350MHz Approx. 2div or 20mV
GDS-350X:
DC ~ 50MHz Approx. 1div or 1.0mV
50MHz ~ 150MHz Approx. 1.5div or 15mV
150MHz ~ 350MHz Approx. 2div or 20mV
350MHz ~ 500MHz Approx. 2.5div or 25mV
External
Trigger
Range
±15V
Sensitivity
GDS-31XX ~ GDS-33XX:
DC ~ 150MHz Approx. 100mV
150MHz ~ 250MHz Approx. 150mV
250MHz ~ 350MHz Approx. 150mV
350MHz ~ 500MHz Approx. 200mV
Input
Impedance
1MΩ ±3%, ~16pF
Horizontal
Timebase
Range
GDS-31XX, GDS-32XX, GDS-33XX:
1ns/div ~ 100s/div (1-2-5 increments); ROLL :
100ms/div ~ 100s/div
GDS-350X:
1ns/div ~ 100s/div (1-2.5-5 increments); ROLL :
100ms/div ~ 100s/div
Pre-trigger
10 div maximum
Post-trigger
1000 div maximum. The number of divisions
depends on the time division.
Timebase
Accuracy
±20 ppm over any ≧1 ms time interval
X-Y Mode
X-Axis Input
Channel 1; Channel 3
Y-Axis Input
Channel 2; Channel 4
Phase Shift
±3° at 100kHz
Signal
Acquisition
Real Time
Sample Rate
150/250/300MHz models: 5GSa/s (MAX)
150/250MHz models with 2CH: 2.5GSa/s
500MHz models: 4GSa/s (MAX), 2GSa/s per
channel