GW Instek GDS-3000 Series - Page 21

GETTING STARTED
21
Reference Key
R
Press the Reference key to set or
remove reference waveforms.
BUS Keys
B1
B2
The Serial bus decode keys are
used for UART, I
2
C and SPI serial
bus interface decoding. The serial
bus decode function is an optional
extra. See page 94 for details.
Function Keys
The Function Keys are used to enter and configure
different functions on the GDS-3000.
Measure
Configures and runs automatic
measurements.
Cursor
Configures and runs cursor
measurements.
Test
Test
Configures and runs GW Instek
applications and optional
functions such as the Power
Analysis measurement software.
Acquire
Configures the Acquisition mode.
Display
Configures the display settings.
Help
Shows the Help menu.
Save/Recall
Used to save and recall
waveforms, images and panel
settings.
Utility
Configures the print/save key,
display time, language and
calibration.