GW Instek GPE-1326 Series - Setting Voltage Lock from Front Panel; Set the Output State at Startup

SETUP
29
Setting Voltage Lock from Front Panel
Background /
Connection
The lock function of the GPE-1326/ 2323/ 3323/
4323 series can be used when you need to keep the
output voltage constant to avoid the load from
being damaged due to inadvertent operation. The
voltage lock takes the present channel settings as
the reference levels. The voltage lock function only
applies to CH1 & CH2.
Panel operation
Press the LOCK key (for
more than 2 seconds) to lock
the voltage knob operation
for CH1 & CH2 in the front
panel. The Lock icon will
become lit.

  
To unlock, press the LOCK key for more than 2
seconds. The Lock icon will then turn off and the
output turns off as well.
Note
 The OUTPUT key is not
affected by the lock
operation.
 It is normal for the
output voltage to have a
fluctuation of around
20mV after the voltage
settings are locked.
  
Set the output state at startup
Background /
Connection
Through the following steps, you can set the
output state of the GPE-1326/2323/3323/4323
series at its next startup. There are two choices, ON
and OFF available for selection.