GW Instek GSP-9300 - Restoring Default Settings

GSP-9300 Quick Start Guide
32
5. Press
System
>More 1/2[F7]>Upgrade[F2].
6. The spectrum analyzer will automatically find
the firmware on the USB flash drive and start
to update the firmware. When finished, the
message “Upgrade is finished” will be shown
at the bottom of the screen followed by
“Rebooting”.
Rebooting
7. The system will automatically restart after the
rebooting message.
Note
The upgrade process may take a few minutes.
Restoring Default Settings
Description
The factory default settings or user presets can
be easily restored using the Preset key on the
front panel. By default, the factory default
settings are restored with the Preset key.
Steps
1. Press
Preset
.
2. The spectrum analyzer will load the preset
settings.