GW Instek LCR-6002 - APERture, FETCh, COMParator Subsystems

Command Reference
108
11.9 APERture Subsystem
The APERture subsystem command sets the integration time of the ADC and
the averaging rate.
Figure 11-6 APERture Subsystem Command Tree
Command
Syntax
APERture {SLOW,MED,FAST}
APERture <value>
SPEED(spd) {SLOW,MED,FAST}
SPEED(spd) <value>
Parameter
Where,
SLOW Set test speed to slow
MED Set test speed to medium
FAST Set test speed to fast
<value> NR1(0 to 256): Averaging rate (0=OFF=1)
Example
SEND> APER FAST<NL>
SEND> APER 10<NL>
Query Syntax
APER?
Query Response
{SLOW,MED,FAST},<avg value>
Example
SEND> APER?<NL>
RET> slow,0<NL>
11.9.1 APERture:RATE?
The APERture:RATE? query returns the current integration time.
Query Syntax
APER:RATE?
Query Response
SLOW
Example
SEND> APER:RATE?<NL>
RET> slow<NL>
11.9.2 APERture:AVG?
The APERture:AVG? query returns the averaging rate settings.
Query Syntax
APER:AVG?
Query Response
<NR1>
Integer (0 to 256)
Example
SEND> APER:AVG?<NL>
RET> 0<NL>
APERture
{SLOW,MED,FAST}
<averaging rate value:NR1>