GW Instek LCR-6002 - Fetch:impedance; Fetch:main; Fetch:monitor1?;2; Fetch:monitor

Command Reference
110
11.10.2 FETCh:IMPedance?
The FETCh:IMPedance? query sets the latest measurement data of the
primary parameter, secondary parameter, monitor1 and monitor2 results into
the output buffer.
Query Syntax
FETCh:IMPedance?
Query Response
<NR3:primary value>,<NR3:secondary value>,
<NR3:monitor1>,<NR3:monitor2>,<comparator
result>
Example
SEND> FETC:IMP?<NL>
RET> +2.61788e-11,+5.45442e-01,+3.88651e+05,
+0.00000e+00,BIN1,AUX-OK, OK<NL>
RET> +1.23434e+05,BIN1,OK<NL>//DCR &
Comp on.
11.10.3 FETCh:MAIN?
The FETCh:MAIN? query sets the latest measurement data of the primary
and secondary parameters.
Query Syntax
FETCh:MAIN?
Query Response
<NR3:primary value>,<NR3:secondary value>
Example
SEND> FETC:MAIN?<NL>
RET> +2.02100e-11,+1.64422e-01<NL>//LCR
Primary,Secondary
RET> +1.23434e+05<NL>//DCR
11.10.4 FETCh:MONitor1? /2?
The FETCh:MONitor1? and FETCh:MONitor2 set the latest measurement
data of the moniter1 and moniter2 parameters into the output buffer.
Query Syntax
FETCh:MONitor1? and FETCh:MONitor2?
Query Response
<NR3: moniter1/2 value>
Example
SEND> FETC:MON1?<NL>
RET> +3.88651e+05<NL>
RET> +0.00000e+00<NL>//0: The monitor 1 is
OFF
11.10.5 FETCh:MONitor?
The FETCh:MONitor? sets the latest measurement data of the moniter1 and
moniter2 parameters into the output buffer.
Query Syntax
FETCh:MONitor?
Query Response
<NR3: moniter1/2 value>