GW Instek LCR-6002 - Overview; Introduction

Overview
14
2. OVERVIEW
This chapter contains general information about LCR-6000 Series .The
information is organized as follows.
 Introduction
 Main Specifications
 Feature overview
2.1 Introduction
Thank you for purchasing an LCR-6000 Series LCR
meter.
The GW INSTEK LCR-6000 Series is a general-purpose
LCR meter for incoming inspection of components,
quality control, and laboratory use.
The LCR-6000 Series is used for evaluating LCR
components, materials, and semiconductor devices over a
wide range of frequencies (10 Hz to 300 kHz) and test
signal levels (10.00mV to 2.00V & 100.0uA to 20.00mA).
With its built-in comparator, the LCR-6000 Series can
output comparison/decision results for sorting
components into a maximum of ten bins. Furthermore,
by using the handler interface, the LCR-6000 Series can
be easily combined with a component handler, and a
system controller to fully automate component testing,
sorting, and quality-control data processing.
The list meas function permits entry of up to 10
frequencies or test signal levels points to be automatically
measured.