PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
26
GPIB or RS-232 and press [ENTER] to confirm the setting. If want to set
to GPIB, use knob to select input address, then press [ENTER] to
complete GPIB setting. If want to set to RS-232, use knob to select input
BAUD rate, then press [ENTER] to complete RS-232 setting.
Remark: When enter GPIB/RS-232 setting, can press again [SHIFT]
[GPIB/RS-232] to leave the function.
For example: Select GPIB communication interface and set the
ADDRESS to 08.
Press [SHIFT] [GPIB/RS-232], use wheel knob to select GPIB and press
[ENTER] to confirm the setting. Then use wheel knob to select [08] and
press [ENTER] to complete GPIB setting.
PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
27
For example: Select RS-232 communication interface and set the BAUD
rate to 9600.
Press [SHIFT] [GPIB/RS-232], use wheel knob to select RS-232 and
press [ENTER] to confirm the setting. Then use wheel knob to select
[9600] and press [ENTER] to complete RS-232 setting.
z ENTER : The key for input confirmation.
z SHIFT : The push-button to select the second level function.
To Next Page
Loading...
Need help?
General
