PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
30
For example: Set the “I STEP” to 1.000A.
Press [SHIFT] [I STEP], then input [1][.][0][0][0][ENTER] to complete
and store the current step setting.
z DISPLAY LIMIT : Switch panel display to the voltage/current
setting mode.
Display the present voltage and current value, this function can be
operated both on Output on and off.
Switch to the voltage/current setting mode by pressing [DISPLAY
LIMIT], then press again [DISPLAY LIMIT] for several seconds to leave
the setting mode and back to the measurement mode or “OUTPUT OFF”.
The operation of the voltage/current setting can be matched with the [V
SET] or [I SET] to change the output value. When set the output to ON,
the change of value will be reacted to the output immediately.
PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
31
5-3. Operation Method
The applied Voltage/Current Unit for this series instruments is Volt and
Amp.
z Constant Voltage Operation
1) Connect load to output terminal:
For the safety, when connect the load to output terminals of (+)
and (-), it must turn off the power.
2) Select output range:
Turn on the power after the load is well connected, select the
adequate operation range by pressing [SHIFT][8V/20A] or
[SHIFT][20V/10A]).
3) Set the current limit value:
Press [I SET], the panel operation is set to current value input
mode, set the desired change value by using the number key or
the wheel knobs (the wheel knob can be used together with [<] or
[>] to adjust the resolution).
4) Set the desired output voltage value:
Press [V SET], the panel operation is set to voltage value input
mode, change to the desired value by using the number key or
the wheel knobs (the wheel knob can be used together with [<] or
[>] to adjust the resolution).
To Next Page
Loading...
Need help?
General
