PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
ix
Declaration of Conformity
We
GOOD WILL INSTRUMENT CO., LTD.
No. 7-1, Jhongsing Rd., Tucheng City, Taipei County 236, Taiwan
GOOD WILL INSTRUMENT (SUZHOU) CO., LTD.
No. 69 Lushan Road, Suzhou New District Jiangsu, China.
declare that the below mentioned product
PSM-3004/6003/2010
are herewith confirmed to comply with the requirements set out in the Council Directive on
the Approximation of the Law of Member States relating to Electromagnetic Compatibility
(89/336/EEC, 92/31/EEC, 93/68/EEC) and Low Voltage Equipment Directive
(73/23/EEC, 93/68/EEC).
For the evaluation regarding the Electromagnetic Compatibility and Low Voltage
Equipment Directive, the following standards were applied:
◎ EMC
EN 61326-1: Electrical equipment for measurement, control and laboratory use –– EMC
requirements (1997+A1: 1998+A2:2001)
Conducted and Radiated Emissions
EN 55011: 1998
Electrostatic Discharge
EN 61000-4-2: 1995+A1:1998+A2:2001
Current Harmonic
EN 61000-3-2: 2000
Radiated Immunity
EN 61000-4-3: 1996+A1:1998+A2 :2001
Voltage Fluctuation
EN 61000-3-3: 1995+A1:2001
Electrical Fast Transients
EN 61000-4-4: 1995+A2:2001
-------------------------
Surge Immunity
EN 61000-4-5: 1995+A1:2001
-------------------------
Conducted Susceptibility
EN 61000-4-6: 1996+A1:2001
-------------------------
Power Frequency Magnetic Field
EN61000-4-8 :1993+A1:2001
-------------------------
Voltage Dips/ Interrupts
EN 61000-4-11: 1994+A1:2001
◎ Safety
Low Voltage Equipment Directive 73/23/EEC & amended by 93/68/EEC
IEC/EN 61010-1: 2001
PSM-SERIES PROGRAMMABLE POWER SUPPLY
USER MANUAL
1
1. PRODUCT INTRODUCTION
1-1. Description
PSM-series Programmable Power Supply is controlled by Micro Processor
Unit (MPU) with extreme high accuracy of 200W maximum, and the single
output with double range (switching between the main panel and
communication interface) that can easily connect communication interface
RS-232 or GPIB to computer in order to satisfy users’ demand for auto-testing
and auto-control. The software commands are fully complied with the SCPI
format, it’s convenient for user to proceed auto-tested and auto-controlled
application program.
The voltage and current are completely controlled by 16 bits D/A
Converter with higher resolution and accuracy. Also, the digitalization of
system makes a speedy, precise and convenient input of information controlled
by keyboard.
The adjustment of voltage/current is made by software calibration without
manual error that will increase the preciseness of the instrument.
The function of Over Voltage Protection (OVP) and Over Current
Protection (OCP) is set with software and detected with hardware to achieve
protected function precisely and speedily in order to secure users from danger
by using the instrument.
If need further technique support or update information, please enter our
web-side: http://www.goodwill.com.tw
To Next Page
Loading...
