7
display irf topology
Use display irf topology to display IRF fabric topology information.
Syntax
display irf topology
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display the IRF fabric topology.
<Sysname> display irf topology
Topology Info
-------------------------------------------------------------------------
IRF-Port1 IRF-Port2
MemberID Link neighbor Link neighbor Belong To
1 DOWN --- UP 2 000f-cbb8-1a82
2 UP 1 DIS --- 000f-cbb8-1a82
Table 4 Command output
IRF-Port1 Information about IRF-port 1, including its link state and neighbor.
IRF-Port2 Information about IRF-port 2, including its link state and neighbor.
MemberID IRF member ID.
Link
Link state of the IRF port:
• UP—The IRF link is up.
• DOWN—
The IRF link is down because the port has no physical link or
has not been activated by the irf-port-
active command.
• DIS—No physical interfaces have been bound to the IRF port.
• TIMEOUT—IRF hello interval has timed out.
• ISOLATE—The device is isolated from the IRF fabric. This issue might
be caused by the following reasons:
The IRF fabric does not support the device model.
The maximum number of member devices has exceeded the upper
limit.
neighbor
IRF member ID of the device connected to the IRF port.
This field displays three hyphens (---) if no device is connected to the port.
Belong To
IRF fabric that has the device, represented by the CPU MAC address of the
master in the IRF fabric.
Related commands
display irf
display irf configuration
To Next Page
Loading...
