20
Predefined user roles
network-admin
Parameters
priority: Specifies an IRF member priority value in the range of 1 to 32. The greater the priority
value, the higher the priority. A member with higher priority is more likely to be the master.
Usage guidelines
The member priority configured in standalone mode takes effect after you enable IRF mode.
To change the member priority of a device in IRF mode, use the
irf member priority
command. The new priority setting takes effect at the next master election, but it does not trigger a
master election.
Examples
# (In standalone mode.) Assign IRF member priority 32 to the device.
[Sysname] system-view
[Sysname] irf priority 32
Related commands
irf member priority
irf-port
Use irf-port to enter IRF port view.
Use undo irf-port to remove all port bindings on an IRF port.
Syntax
In standalone mode:
irf-port irf-port-number
undo irf-port irf-port-number
In IRF mode:
irf-port member-id/irf-port-number
undo irf-port member-id/irf-port-number
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies an IRF member device by its member ID.
irf-port-number: Specifies an IRF port on the member device. The irf-port-number
argument represents the IRF port index and must be 1 or 2.
Usage guidelines
To bind physical interfaces to an IRF port, you must enter IRF port view.
Examples
# (In standalone mode.) Enter IRF-port 1 view.
<Sysname> system-view
To Next Page
Loading...
