H3C MSR 810 - Irf Member Description; Irf Member Priority

17
Parameters
member-id: Assigns an IRF member ID to the device. The member ID can be 1 or 2.
Usage guidelines
Assign an IRF member ID to a device before enabling IRF mode. The member ID takes effect after
IRF mode is enabled. This member ID must be unique among all IRF member devices.
To change the member ID of a device in IRF mode, use the
irf member renumber command.
Examples
# (In standalone mode.) Assign member ID 2 to the device.
<Sysname> system-view
[Sysname] irf member 2
Related commands
irf member renumber
irf member description
Use irf member description to configure a description for an IRF member device.
Use
undo irf member description to restore the default.
Syntax
irf member member-id description text
undo irf member member-id description
Default
No description is configured for an IRF member device.
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies the ID of an IRF member.
text: Specifies a description, a string of 1 to 127 characters.
Usage guidelines
This command is supported only in IRF mode. When you change the operating mode from IRF to
standalone, the IRF member description is lost, regardless of whether you have saved the
configuration.
Examples
# Configure the description as F1Num001 for IRF member 1.
<Sysname> system-view
[Sysname] irf member 1 description F1Num001
irf member priority
Use irf member priority to change the priority of an IRF member device.