H3C MSR810 - Installing the Router; Mounting the Router on a Workbench

9
Figure 4 Installation flowchart
Installing the router
Mounting the router on a workbench
IMPORTANT:
• Make sure the workbench is clean, stable, and reliably grounded.
• Maintain a minimum clearance of 100 mm (3.94 in) around the router for heat dissipation.
• Do not place heavy objects on the router.
To mount the router on a workbench:
1. Place the router upside down on the workbench and attach the rubber feet to the four round
holes in the chassis bottom.
2. Place the router upside up on the workbench.
Start
Determine the
installation position
End
Connect the grounding cable
Install antennas
Mount the router on a
workbench
Mount the router on a
wall
Mount the router in a rack
Connect interface cables
Connect the router to a
configuration terminal
Connect the power adapter or
power cord
Verify the installation
Power on the router
Operating correctly?
Troubleshooting the
router
Power off the router
Yes
No