H3C MSR810 - Supplying Power to a Terminal through Poe

21
Figure 19 Installing a GPS antenna
Supplying power to a terminal through PoE
Only the RT-MSR810-10-PoE router supports PoE. To supply power to a terminal, the terminal
must support PoE.
To supply power to a terminal through PoE:
1. Connect one end of the cable to an Ethernet port on the router.
2. Connect the other end of the cable to the Ethernet port on a terminal.
3. Examine the port LEDs on the router. For more information about the LEDs, see "LED
descri
ption."