H3C MSR810 - Rt-Msr810-Lms;Rt-Msr810-Lms-Ea;Rt-Msr810-Lus; LED Description

56
RT-MSR810-LMS/RT-MSR810-LMS-EA/RT-MSR810-LUS
Figure 65 Front panel LEDs
(1) System status LED (SYS) (2) VPN status LED (3) SIM0 slot LED
(4) SIM1 slot LED (5) Signal strength LED (6) FE port LEDs (FE0 through FE3)
LED description
LED Status Description
System status LED
(SYS)
Steady green The SDRAM is performing self-test.
Flashing green (8 Hz)
The system software image is being copied and
decompressed.
Flashing green (1 Hz)
Comware has started with the configuration file and
the router has booted up.
Flashing yellow (1 Hz) The SDRAM has failed the self-test.
Flashing yellow (8 Hz) The extended segment does not exist.
Steady yellow The system software image does not exist.
Off No power input, or exceptions have occurred.
VPN status LED (VPN)
Steady on A minimum of one IPSec VPN tunnel is present.
Off No IPSec VPN tunnel is present.
GE port green LED
and GE port yellow
LED
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 10/100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 10/100 Mbps.
Both LEDs off No link is present.
FE port LED (FE0
through FE3)
Steady green A 10/100 Mbps link is present.
Flashing green Data is being received or transmitted at 10/100 Mbps.
Off No link is present.