H3C MSR810 - Mounting the Router on a Wall

To Next Page

To Previous Page

Figure 5 Mounting the router on a workbench

Mounting the router on a wall

Only the following routers support wall mounting:

• RT-MSR810

• RT-MSR810-LM

• RT-MSR810-LM-CNDE-SJK

• RT-MSR810-W-DB

• RT-MSR810-W

• RT-MSR810-W-LM

• RT-MSR810-LM-HK

• RT-MSR810-W-LM-HK

• RT-MSR810-LM-GL

• RT-MSR810-W-LM-GL

To mount the router on a wall:

1. Mark two screw hole locations on the wall. Make sure the two holes are 160 mm (6.30 in)

horizontally apart.

2. Drill holes with a minimum depth of 22 mm (0.87 in) in the marked locations.

3. Hammer an anchor into each hole until the anchor is flush with the wall.

4. Drive a screw into each anchor and make sure the screw protrudes a minimum of 1.5 mm

(0.06 in) from the wall.

5. Hang the router on the screws.

Position the router so the network interfaces face downwards, and the sides with ventilation

openings are perpendicular to the ground, as shown in Figure 6.

Other manuals for H3C MSR810