Installation Manual
H3C S1526 Smart Ethernet Switch
Chapter 2 Installation
2-3
z Electromagnetic shielding approach is adopted when
necessary, such as using shielded port cable.
z All port cables are wired indoor, to prevent the ports from
any damage that may be caused by overvoltage and
overcurrent from lightning strike.
2.2 Installing the Switch
Caution:
There is a seal on one mounting screw on the chassis of the switch.
This seal must remain intact unless the agent is on the spot to
maintain your switch. Please contact your local agent and get
permission if you need to open the chassis. Otherwise, you will have
to bear the responsibilities for all the serious consequences arising
therefrom.
2.2.1 Installing the Switch into a 19-Inch Rack
Follow the steps below to mount the switch in a 19-inch
standard rack.
1) Check that the rack is sturdy and properly earthed.
2) Use the screws to fix the mounting ears to both sides of the
front panel of the switch.
To Next Page
Loading...
Need help?
General
