H3C UniServer R4900 G3 Series - Riser Cards; Riser Card Guidelines; Pcie Slot Numbering

59
NIC-10GE-2P-560T-L2
Item Specifications
Dimensions 128 × 68 mm (5.04 × 2.68 in)
Ports 2
Connector RJ-45
Data rate 1/10 Gbps
Bus type 10G-KR ×2
NCSI Supported
NIC-10GE-2P-560F-L2
Item Specifications
Dimensions 128 × 68 mm (5.04 × 2.68 in)
Ports 2
Connector SFP+
Data rate 10 Gbps
Bus type 10G-KR ×2
NCSI Supported
Riser cards
To expand the server with PCIe modules, you can install riser cards on the PCIe riser connectors.
Riser connector 1 is for processor 1, riser connectors 2 and 3 are for processor 2. The PCIe slots in
a riser card are numbered differently depending on the riser card model and the PCIe riser connector
that holds the riser card.
Riser card guidelines
Each PCIe slot in a riser card can supply a maximum of 75 W power to the PCIe module. You must
connect a separate power cord to the PCIe module only if it requires more than 75 W power.
PCIe slot numbering
The server provides a maximum of eight PCIe slots, as shown in Figure 32.
Figure 32 PCIe slots at the rear panel