H3C UniServer R4900 G3 User Manual

15
Section Description
• Create RAID arrays.
• Delete RAID arrays.
• Reset drives to non-RAID.
• Mark drives as spare.
• Exit.
DISK/VOLUME INFORMATION
In the
DRIVE/VOLUME INFORMATION
section on the lower part
of the page, you can view brief information about existing RAID
arrays and physical drives.
Configuring RAID arrays
1. On the RSTe configuration screen as shown in Figure 22, select Create RAID Volume, and
press Enter.
Figure 22 RSTe configuration screen
2. On the screen as shown in Figure 23, set the Name, RAID Level, Disks, Strip Size, and
Capacity parameters, select Create Volume, and press Enter to create the RAID volume.
Table 4 describes the configuration parameters for creating a RAID volume.

H3C UniServer R4900 G3 Specifications

General

Brand	H3C
Model	UniServer R4900 G3
Category	Server
Language	English