EasyManuals Logo

H3C WA2600 series User Manual

H3C WA2600 series
447 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #159 background imageLoading...
Page #159 background image
146
Configuring the PPPoE client
1. Create a PPPoE client:
a. Select Network > PPPoE from the navigation tree.
The system automatically enters the Client page.
b. Click Add to enter the page shown in Figure 153.
c. To cr
eate a PPPoE client:
î™» Enter 1 as the dialer interface name.
î™» Enter user1 as the username.
î™» Enter hello as the password.
î™» Select the IP configuration mode PPP Negotiate.
î™» Select the interface to be bound Vlan-interface1.
î™» Select the session type Always Online.
d. Click Apply.
Figure 153 Create a PPPoE client
Configuring the PPPoE server
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and password
that are the same as those configured on the PPPoE client, and assign an IP address to the peer end of
the PPP connection. Detailed configurations are not discussed here.
Verifying the configuration
Display the summary information of PPPoE sessions on an AP.

Table of Contents

Other manuals for H3C WA2600 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C WA2600 series and is the answer not in the manual?

H3C WA2600 series Specifications

General IconGeneral
BrandH3C
ModelWA2600 series
CategoryWireless Access Point
LanguageEnglish

Related product manuals