20 96-0012 rev G
June 2003
OM
PERATOR’S ANUAL
Automatic
Automatic
Pallet Changer
Pallet Changer
FMS G CODES
G188: Calls the parts program for the loaded pallet based on the PST entry for the pallet
SETTINGS
146 APC PAL. 3 LOAD X
This is the APC pallet #3 X axis load position. It should be set at the time the Quad APC is installed. Units are
inch/mm.
147 APC PAL. 3 LOAD Y
This is the APC pallet #3 Y axis load position. It should be set at the time the Quad APC is installed. Units are
inch/mm.
148 APC PAL. 3 UNLOAD X
This is the APC pallet #3 X axis unload position. It should be set at the time the Quad APC is installed. Units
are inch/mm.
149 APC PAL. 3 UNLOAD Y
This is the APC pallet #3 Y axis unload position. It should be set at the time the Quad APC is installed. Units
are inch/mm.
150 APC PAL. 4 LOAD X
This is the APC pallet #4 X axis load position. It should be set at the time the Quad APC is installed. Units are
inch/mm.
151 APC PAL. 4 LOAD Y
This is the APC pallet #4 Y axis load position. It should be set at the time the Quad APC is installed. Units are
inch/mm.
152 APC PAL. 4 UNLOAD X
This is the APC pallet #4 X axis unload position. It should be set at the time the Quad APC is installed. Units
are inch/mm.
153 APC PAL. 4 UNLOAD Y
This is the APC pallet #4 Y axis unload position. It should be set at the time the Quad APC is installed. Units
are inch/mm.
154 APC PAL. 3 & 4 SAFE X
This is the receiver X axis position where it is safe to open the door. It should be set at the time the Quad APC
is installed. Units are inch/mm.
PROGRAMMING
To Next Page
Loading...