Haas Automatic Pallet Changer - 3.0 INSTALLATION; TOOLS REQUIRED; GENERAL REQUIREMENTS; 3.1 VF;APC FOOTPRINT

96-0012 rev G
5
June 2003
OM PERATOR’S ANUAL
Automatic
Autom a t i c
Automatic
Autom a t i c
Pallet Changer
Pallet Changer
INSTALLATION
3.0 INSTALLATION
TOOLS REQUIRED:
• Machinists' level (2) • Forklift capable of lifting 5,000 lbs, with forks at least 6' long
• 6' straightedge • Included - APC chain rotation tool (P/N 20-0102)
• Allen wrenches • Included - APC jumper
Prior to installing your VMC, make certain that there is enough floor space on the right-hand side of the VMC to
place the APC. The APC will add approximately 52
1
/
2
" (58
1
/
2
" for the VF-4) to the width of the VMC. Ensure
that all the air and power requirements for the VMC have been met.
GENERAL R EQUIREMENTS
Operating Temperature Range 41°F to 104°F (5 to 40°C)
Storage Temperature Range -4°F to 158°F (-20 to 70°C)
Ambient Humidity: less than 90% relative humidity, non-condensing
Altitude: 0-7000 ft.
3.1 VF/APC FOOTPRINT
VF 3/4 WITH APC FOOTPRINT