EasyManuals Logo

Hach Micro Dist User Manual

Hach Micro Dist
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Section 3 Installation
DANGER
Burn hazard. Only qualified personnel should conduct the
tasks described in this section.
DANGER
Risque de brûlure. Les opérations décrites dans cette section
ne doivent être exécutées que par un personnel qualifié.
3.1 Unpacking the Instrument
Keep the original shipping cartons. Returns for service must be
transported in the original packaging.
3.1.1 Micro Dist Setup
CAUTION
Personal injury hazard. The Micro Dist is heavy. To prevent
possible lifting related injuries, do not attempt to carry or
move the product without assistance from a second person.
ATTENTION
Risque de blessure personnelle. Le Micro Dist est lourd. Pour
empêcher les blessures potentielles que sa manutention
pourrait occasionner, n'essayez pas de porter ou de déplacer
le produit sans l'aide d'une deuxième personne.
To move the Micro Dist, position a person on each side of the
instrument. With both hands under the side, lift the analyzer
simultaneously.
Place the instrument on a flat surface that it is not exposed to
direct sunlight.
To avoid overheating or damage to the surrounding area during
operation, allow six inches of clearance around the Micro Dist.
3.1.2 Connecting the Power Supply
DANGER
Electric shock hazard. A protective earth ground is required
for safe operation of this equipment. Always use a power cord
and plug that has a protective earth ground terminal
connection.
DANGER
Risque de décharge électrique. Une prise de terre protectrice
est requise pour pouvoir utiliser cet équipement sans danger.
Utilisez toujours un câble d'alimentation et une prise ayant des
fiches pouvant être branchées sur une prise de terre.
DANGER
Electric shock and fire hazard. Secure the power cord position
to prevent contact with the heater block.
DANGER
Risque de décharge électrique et danger d'incendie. Placez le
câble d'alimentation de telle manière qu'il ne puisse pas entrer
en contact avec le bloc de chauffage.
Note: For wet location installation, use a ground fault interrupt circuit
(GFIC).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hach Micro Dist and is the answer not in the manual?

Hach Micro Dist Specifications

General IconGeneral
BrandHach
ModelMicro Dist
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals