13
Section 4 Operation
4.1 Setting the Temperature
4.1.1 Heater Block
CAUTION
Burn hazard. The Micro Dist heater block top surface is a burn
hazard at operating temperature. Wear heat-resistant gloves
when putting tubes in or taking them out of the heating block.
If a burn occurs, immediately put the burned area under cold
running water for five minutes. Seek appropriate medical
attention if the area is blistered or white.
ATTENTION
Risque de brûlure. La surface supérieure du Micro Dist
présente un risque de brûlure à la température d'utilisation.
Veuillez porter des gants résistants à la chaleur lorsque vous
mettrez des tubes à l'intérieur ou quand vous les enlèverez du
bloc de chauffage.
En cas de brûlures, passer immédiatement les zones de peau
brûlées sous l'eau froide pendant cinq minutes. Si la zone
touchée est couverte d'ampoules ou présente une coloration
blanche, demander l'aide d'un médecin.
If a large amount of liquid is spilled on the heating block, unplug it
immediately. Do not turn off at the power switch. The Micro Dist
enclosure and block are grounded, but it is best to allow the spill to
dry before using the block again. Rinse the holes with water and
drain through the drain-hole at the bottom.
To set the temperature, locate the heater control on the top right.
See Table 1.
Figure 1 Heater Control
To Next Page
Loading...
Need help?
General
