Adding a New Program
There are eight programs available, 1 through 4. Each program accepts
one Ultima Gas Monitor command.
To enter a new program:
1. Press and hold the PROGRAM button until the display prompt
reads: ENTER PRGM #.
2. Enter the program number (1 through 4).
NOTE: A dual beep tone is heard for each entry during the
Calibrator programming mode.
3. Press the ENTER button.
4. Enter the keystrokes of the single Ultima Gas Monitor function
desired. When all of the keystrokes are entered, the Controller
saves them and displays: SAVING--- for three seconds.
5. Repeat steps 1 through 4, using a different program number to
program additional Ultima Gas Monitor functions.
To Use Programs 1 through 4
1. Press the PROGRAM button.
• The display prompts: PROGRAM #.
2. Enter the desired program number (1 through 4).
3. Aim the Controller at the Ultima Gas Monitor
and press the ENTER button.
• The Ultima Gas Monitor responds immediately.
3-20
To Next Page
Loading...
Need help?
General
