INSTALLATION
Eaton
®
9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality
19
Rackmount Installation
The Eaton 9130 rackmount cabinet comes with all of the hardware
required for installation in a standard EIA or JIS seismic rackmount
configuration with square and round mounting holes. The rail assemblies
adjust to mount in 48-cm (19-inch) racks with front to rear rail distances
from 61 to 76 cm (24 to 30 inches) deep.
Checking the Rail Kit Accessories
Verify that the following rail kit items are included for each cabinet:
S Left rail assembly:
- Left rail
- Rear rail
- (3) M4
8 pan-head screws
S Right rail assembly:
- Right rail
- Rear rail
- (3) M4
8 pan-head screws
S Rail hardware kit:
- (10) M6
16 pan-head screws
- (10) M6 cage nuts
- (2) rear stop brackets
- (2) M3
8 pan-head screws
S Mounting bracket kit:
- (2) mounting brackets
- (8) M4
8 flat-head screws
Tools Required
To assemble the components, the following tools may be needed:
S Medium flat-bladed screwdriver
S Phillips #2 screwdriver
S 7 and 8 mm wrench or socket
To Next Page
Loading...
Need help?
General
