Need help?Do you have a question about the hager EGN100 and is the answer not in the manual?
General| Type | Time switch |
|---|---|
| Product color | Gray |
| Wire size range | 0.2 - 4 mm² |
| Built-in display | No |
| Housing material | Plastic |
| Number of modules | 1 |
| Protection features | Scratch resistant |
| Compatible load types | Single-phase AC motor |
| Connectivity technology | Wired |
| International Protection (IP) code | IP20 |
| AC input voltage | 230 V |
| AC voltage range | 230 - 254 V |
| AC input frequency | 50 - 60 Hz |
| Storage temperature (T-T) | -25 - 70 °C |
| Operating temperature (T-T) | -5 - 45 °C |
| Operating relative humidity (H-H) | 0 - 95 % |
Weight and Dimensions| Depth | 62.5 mm |
|---|---|
| Width | 17.8 mm |
Connect the time switch to mains power and add it as a device in the app.
Accept the pairing request, enter the code, and confirm the connection.
Press a button on the timer, identify, name, and confirm the device.
Tap '+' to create a new program or select a template.
Manually load the program from the key onto the EGN103 time switch.
Program to switch on light when brightness is below 100 lux.
Select Brightness trigger and set the 'Lower than' value.
Program to switch off light when brightness is above 100 lux.
Check and synchronize the twilight program with the device.
To Next Page
