GB
14
• < > FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3rd stops.
It is useful in situations where minor adjusting of the TTL system is
needed based on the environment.
< > High-Speed Sync
Press the <SYNC> button and < - HSS> is displayed on the LCD
panel. Now you can set the camera shutter speed higher than 1/250.
< > Second-Curtain Sync (Rear-Curtain Sync)
Press the <SYNC> button again < > is displayed on the LCD
panel.
Press the <SYNC> button again to return to first curtain sync.
Setting FEC:
1 Press the <SET> Button and the
flash exposure compensation
amount will be highlighted on the
LCD panel
2 Turn the Select Dial to set the
amount.
● “0.3”means 1/3 step, “0.7”means
2/3 step.
● To cancel the flash exposure
compensation, set the amount
to “0”.
3 Press < SET > button again to
confirm the setting.
• With high-speed sync, the faster the shutter speed, the shorter the
effective range.
• Try to avoid using high-speed sync flash, to extend the flash tube’s
lifetime.
• Over-temperature protection may be activated after 15 consecutive
high-speed flashes.
• MULTI Flash mode cannot be set in high-speed sync mode.
• LCD will display “Hi” (blinking for 3 sec.) when flash output is up
to maximum value. If the photo is underexposed, adjust camera
parameters accordingly.
• LCD will display “Lo” (blinking for 3 sec.) when flash output is
at minimum value. If the photo is overexposed, adjust camera
parameters accordingly.
To Next Page
Loading...
