Hahnel MODUS 360RT - Multi Wireless Stroboscopic Flash Shooting; Multi Wireless Flash Setup and Group Control

GB
23
5 Check the flash operation
• Press the master unit’s <Test icon flash> Test Button.
• The “Master” and “Slave” unit will then fire. Each group fires at the set flash
output power
1 Master Unit Setting
• Attach 1st Modus 360RT (or Viper
Mini) to camera and set it as the
master unit. (Page 18)
• Long press the <MODE> button
for 2 seconds so that <Multi>
is displayed. Long press the
<MODE> button again for 2
seconds to exit.
2 Setting flash output/flash
frequency/flash times
• Set the flash output/flash
frequency/flash times in Group
<A> for all groups. (see page 16).
3 Turning ON/OFF each group
• Press <Mode> button to turn ON/
OFF group A, B or C individually
MULTI: Wireless shooting with Multi repeating flash
stroboscopic
This describes wireless using stroboscopic flash. Set all parameters
on the master unit.
+ 2 Sec.