GB
26
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the built-in auto
focus assist LED light will automatically switch on to make it easier to
autofocus. The light beam will light up only when autofocus is difficult
and will switch off as soon as the autofocus is set. If you want to turn
off the auto focus assist beam, set “AF” to “OF” on the C.Fn settings.
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will bounce
off the surface before illuminating the subject. This can soften shadows
behind the subject for a more natural-looking shot. This is called
bounce flash.
To set the bounce direction, hold the flash head and turn it to
the required angle.
• If the wall or ceiling is too far away, the bounced flash might be too
weak and result in underexposure.
• The wall or ceiling should be a plain, white color for high reflectance.
If the bounce surface is not white, a colour cast may appear in the
picture.
• If you find the auto focus assist beam does not light up, this is because
the camera has got a correct autofocus.
• The auto focus assist beam does not operate while Continuous AF is
used as the camera focusing mode
• When not attached to the camera, the auto focus assist beam will
not light up.
• Also, check the information in the camera user manual regarding
operation of AF assist beam for your camera model.
270
-7-90
Catchlight Panel
With the catchlight panel, you can create a catchlight in the subject’s
eyes to add life to the facial expression.
To Next Page
Loading...
