Replacement Tip
Temp, compansion with the standard tip.
(At 480°C, 896°F)
_9M
900M-T-1,6D _.=_
M-T-2.4O
.... _ ,,_.o%.,,
900M-T-B
1450"C, 896_F)
900M-T-LB '_
14 ?'O'C. 878"FI
900M-T-1CF* i o
H80_C P_96"F)
900M-T-2C 0 !_-_
900M-T-2CF* o
(4_0,C, 896"_)
900M-T-3C 0 L: .".......
900M-T-3CF* _ _ o
904]M-T-4C 0 !i-_
900M-T-4CF* o
900M-T-K _ __
1510"C 511_F]
900M-T-R © _,_
_OM-T-RT 0 iq_
(4_%;. _°F I
900M-T-I _,
" (4_-C. g7B.F)
9QOM-T-1.8H _
_, _ _"*/_, .,_..,,.,
i_=a_ (470"C, 87e,F)
• 90_ 1ip C_I Dram _ 5
9_OL
900L-T-B-_._,_
@ o
(480"C, e96"F)
900L-T-2B _) "__ o
(480,C, _"F)
900L-T-24D
.... _ <,=-c%w,_
900L-T-3.2D[_) _=___
(,t_'C, 1_6"F)
900L-T-2C _
2ff_. 31PF
9_OL-T-2CF* _ (,_o.c,e_o._)
_L-T-_C@_o_
900L-T-3CF* _'-,_ I-- o
(480_C, B9_,F)
900L-T-4C _=__
o
900L-T-4CF* _ (,,so.c,e_.r)
900L-T-5C _)_'_E _ o
900L-T-5CF* (,mo_._6"FI
9OOL-T-I (_ "_.__ .z,o"c.._
g(]OL'T'K (_ _.____._ ÷_o_:.._
• 900L T@ Out I_am e85
_r These tips are tinnedfiat only.
• Caution
1 ) Use exclusive tips for HAKKO 900 only.
2 ) The set temperature should be adjusted
according to the tip configuration.
If required, adjust the temperature with
"CAL" potentiometer on bottom of sta-
tion when changing tip configurations.
The temperature is increased by turning
"CAL" clockwise.
3 ) When using the Soldering Iron continu-
ously loosen Tip and remove oxide once
a week.
This helps prevent seizure and reduction
of Tip temperature.
4 ) Tin the tip daily as follows ;
1. Clean the Tip.
2. Set the temperature at 200°C (3920F).
3. Melt the solder gradually at the tip.
5 ) For heavy duty soldering, HAKKO re-
commends The 900L Iron with heavier
tips.
• The tip temperature may vary depending
on the figure. Refer to the left chart for the
quick and temporary adjustment.
To Next Page
Loading...
