Trouble Shooting Guide
Problem : Turn the power switch on, but Tip does not heat up or over heating.
Condition : The power lamp doesn't light up.
CheckPoint : Is the fuse blown?
Condition : The fuse is blown.
CheckPoints : 1. Is the inside of the iron short-circuited?
2. Is the grounding spring touching the Heating Element?
3. Is the Heating Element Lead twisted and short-circuited?
Condition : The power lamp lights up but the LED Heater Lamp doesntt blink.
CheckPoints : 1. Is the Connecting Plug connected correctly?
2. ls the Heating Element Lead broken?
Condition : The Power Lamp and The LED Heater Lamp lights up.
CheckPoints : 1. Is the Heating Element broken?
2. Is the Cord Asse'y broken?
Problem : The Tip heats up intermittently.
CheckPoint : 1. Is the Cord Asse'y almost broken?
Problem : The Tip doesn't wet.
CheckPoints : 1. Is the Tip temperature too high?
2. Is the Tip cleaned?
Problem : The Tip doesn't have desired temperature.
CheckPoint " Is the iron calibrated correctly?
Problem : The Tip can not be pulled off.
CheckPoints : 1. Is the Tip seisured?
2. Is the Tip expanded by deterioration.
NOTE: When repairs are needed, please send both the Soldering Iron and the station to your sales agent.
To Next Page
Loading...
