Halton KVF Capture Jet

Questions and Answers

N
Nicole MoralesAug 11, 2025
How to fix Halton KVF Capture Jet not removing cooking fumes?
- S
  Stephanie GilbertAug 11, 2025
  If cooking fumes are not being removed from your Halton Ventilation Hood, several factors could be at play. First, ensure the exhaust fan is powered on and running correctly. Also, verify that the supply air capture jet fan is operational. Check that the exhaust fan is appropriately sized for the required duty. Supply air imbalance can also be a culprit, so check the supply fan and adjust its speed to balance the kitchen. Excessive kitchen drafts can impede fume removal; try closing doors and windows or turning off draft-causing fans. If equipment has been moved from its original position, check the equipment list and revise the exhaust system design as necessary. Finally, service the filters if the secondary treatment system requires it.
R
Robert JohnsonAug 17, 2025
What to do if there is excessive oil and grease at discharge of Halton KVF Capture Jet Ventilation Hood?
- A
  Amanda DixonAug 17, 2025
  To address excessive oil and grease at the discharge of your Halton Ventilation Hood, start by checking the filters. Ensure they are correctly installed, as improperly fitted or overloaded filters can cause this issue. Additionally, inspect the hood and ductwork. Clean the inside of the hood exhaust plenum(s) and ductwork if necessary.
H
hallpaulAug 22, 2025
Why measured exhaust pressures not per rating plate (+/-10%) in Halton KVF Capture Jet Ventilation Hood?
- G
  gonzalezmelissaAug 23, 2025
  If the measured exhaust pressures of your Halton Ventilation Hood are not within +/-10% of the rating plate, begin by checking the exhaust and supply dampers. Adjust them according to the required T.A.B. pressures. Next, inspect the supply and exhaust collars to ensure they have a sufficient seal. If the issue persists, the exhaust or supply fan might be incorrectly sized; replace it with the correct size if needed. Lastly, if your system has an optional VFD, ensure it is adjusted correctly.
W
Whitney MasonAug 29, 2025
How to fix lights not working on Halton Ventilation Hood?
- T
  Taylor RodriguezAug 29, 2025
  If the lights on your Halton Ventilation Hood are not working, first ensure that power is supplied to the lighting circuit. If power is on, check the tubes, starter, and ballast for any faults and replace any damaged components. Also, inspect the wiring for damage or incorrect connections and fix any faulty wiring.
S
Stephen PriceSep 4, 2025
What to do if some lights don’t turn on in Halton KVF Capture Jet Ventilation Hood?
- A
  Angela PowellSep 4, 2025
  If some lights on your Halton Ventilation Hood don’t turn on, start by checking that all lighting connections have been made between each hood section. If the connections are secure, the lights may be faulty and need replacement.