Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
• The process of handling and washing filters can result in them being bent� Check filters for damage to ensure they can be easily refitted�
We recommend each business hold a stock of spare filters to replace damaged filters
• Fluorescent or LED lights in the exhaust hood have a limited service life & require periodic replacement by an authorised technician
• The Capture Jet fan requires annual service & cleaning by an authorised technician
• Airflow checks should be done annually and after service work by measuring the TAB pressure to confirm the exhaust airflow is within
specification and ensure ongoing performance
Maintenance
Lights must only be replaced by a qualified technician� Fluorescent lights are housed within the light fixture to provide sufficient light to the
work area underneath the hood� The lights may be florescent tubes, LED tubes, halogen downlights or LED downlights�
Before replacing any lights ensure power to the hood is switched off�
1� Unlatch the light diffuser panel and swing it downwards
2� Rotate the tube to release it from the tombstone ends and remove it
3� Replace the tube with a tube of the same size and wattage
Replacing Fluorescent / LED Lights
Fluorescent and LED tubes:
IMPORTANT
BEFORE ACCESSING THE LIGHTS,
ENSURE ALL POWER TO THE HOOD IS SWITCHED OFF
Cleaning and Maintenance
To Next Page
Loading...
