Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
1� Pull the downlight down and out of the hood, this can be difficult� There are two spring clamps holding the lamp in� You may need to pry
the light off the surface of the hood and use a screwdriver (or similar) to hold the clamps back� If it is possible, reach on top of the hood
and hold the clamps back
2� Disconnect the light and replace it with a new one
3� If replacing the light doesn’t fix the problem, the driver needs to be replaced by a qualified electrician, service technician or similarly
qualified persons� The driver is attached with Velcro next to the light opening with enough cable to pull it through the hole
Down Lights:
Pull Out
Spring Clamps
Disconnect
Cleaning and Maintenance
To Next Page
Loading...
