Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Cleaning and Maintenance
Note: KSA Filters must be correctly positioned over the top and botom rails
1 2 3
654
Filter Arrangement Filter Removal Filter Arrangement
Post Removal
1� Switch off the exhaust fan
2� Take note of filter positions (to ensure any blind panels are positioned in same location)
3� Lift each filter up and rotate bottom of filter toward you, then lower filter down and out of the hood
4� Wash particulate off the filter in the pot sink with detergent, using spray-rinse and a brush or cloth
5� Place filters in a dishwasher basket (5 per basket) and pass through the dishwasher
6� Dry the filters & re-fit into the hood
7� Make sure the filters are properly located with both top and bottom hanging rails in place� (If there is a Filter to fan interlock, the fan will
not restart when a filter is removed or not positioned properly)
KSA Cyclonic Filters – Remove and Wash
To Next Page
Loading...
