Hama IR150MBT - Automatic Bluetooth Connection (after Successful Pairing); Terminate Bluetooth Connection; 13 Sleep

20
12.2 Automatic Bluetooth
®
connection (after
successful pairing)
• Terminal devices already paired with the radio are
automatically saved on the radio.
Note – Connection impaired
After the radio and terminal device have been paired,
a connection is established automatically. If the
Bluetooth
®
connection is not established automatically,
check the following:
• Check the Bluetooth
®
settings of your terminal device
to see whether IR150MBT is connected. If not, repeat
the steps listed under Bluetooth
®
pairing.
• Check whether your terminal device and the radio are
less than 10 metres apart. If not, move them closer
togehter.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
12.3 Terminate Bluetooth
®
connection
[ ]
Main menu

Terminate connection
• Then select the YES button by turning [ENTER/
NAVIGATE], and conrm termination of the Bluetooth
connection by pressing [ENTER/NAVIGATE].
13. Sleep
The radio has a sleep function, after a dened time the
radio switches to standby mode.
• Repeatedly press [SLEEP] on the remote control to set
the desired time interval (Sleep OFF/15/30/45/60/90/120
minutes).
• Alternatively, set the time interval from the main menu
using [ENTER/NAVIGATE]:
[ ]
Main menu

Sleep
• After the dened time the radio switches to standby
mode.
• Press [VOLUME/POWER], to turn the radio back on.
• If a time interval is already activated, you can change or
disable it at any time by again pressing [SLEEP] on the
remote control.
Note
There is a separate setting for the backlight when the
timer (snooze) is activated. For example, it can be set to
be dimmer than in normal operation 15.9. Backlight.