47
Step 10
Remove the standard servo arm and attach a large
180-degree standard arm on the servo. Position the
servo in the opening with the servo arm facing the rear
of the fuselage. Mark the locations for the servo mounting
screws using a felt-tipped pen.
Step 11
Use a drill and 1/16-inch (1.5mm) drill bit to drill the
locations for the servo mounting screws.
Step 12
Apply a few drops of thin CA into each hole to harden the
surrounding wood. You may need to run the drill bit back
through the holes after applying the CA.
Step 13
Use the servo hardware that came with your servo to
secure the steering servo in the fuselage.
Section 8: Retractable Landing Gear Installation
To Next Page