72
Step 14
All decals will be factory installed.
Step 15
Use RC-56 canopy glue to attach the radiators to the wing.
Step 16
Repeat Steps 13 though 15 to install the remaining
accessories, as there is a right and left to these
accessories.
An important part of preparing the aircraft for flight is
properly balancing the model. This is especially important
when various engines are mounted.
Caution: Do not inadvertently skip this step!
The recommended Center of Gravity (CG) location for the
B-25 Mitchell is 3
3
/
4
-in (95.25mm) behind the leading
edge of the wing against the fuselage. Mark the location
of the CG on the bottom of the wing as shown. Turn the
airframe upright to balance. If necessary, move the battery
pack or add weight to either the nose or the tail until the
correct balance is achieved. Stick-on weights are available
at your local hobby store and work well for this purpose.
Recommended Center of Gravity (CG)
Section 14: Receiver, Battery and Scale Accessories
To Next Page