66
11.2.1 One Sample On Meter
Use this option to log one set of enabled measurement parameters to the meter
memory.
•If there are no lots saved on the meter, press
<New> to create a new lot. Use the keypad to
enter the desired lot name and press <Accept>
to confirm. Press <OK> to log the sample in
the selected lot.
• If there are existing lots on the meter, the meter
will suggest a lot to store the sample. Press
<OK> to use the selected lot or <Options>
to select a different lot. This will add the new
sample data to an existing lot. A new lot can
also be created by pressing <New>. Press
<OK> to log the sample in the selected lot.
• On the “Remarks” window, select <Yes> to go
to the Remarks screen. Press <No> to skip this
option. If <Yes> is selected, select a remark
from the list, or press <New> to create a new
remark.
• On the “Read tag” screen, touch the location’s
iButton
®
with the meter’s tag reader. Otherwise,
press <Skip> to skip this option.
• If the tag is touched, the associated ID will be
displayed. If no ID is associated to the tag, the
serial number is shown.
•Press <Tag ID> to insert an identification code for the tag, then press <OK>.
• To return to the measurement screen, press ESC.
To Next Page
Loading...
