HI98194, HI98195 and HI98196 meters are warranted for two years
(sensors, electrodes and probes for six months) against defects in workmanship
and materials when used for their intended purpose and maintained according
to instructions.
This warranty is limited to repair or replacement free of charge. Damages due to
accidents, misuse, tampering or lack of prescribed maintenance are not covered.
If service is required, contact the dealer from whom you purchased the
instrument.
If under warranty, report the model number, date of purchase, serial number and
the nature of the problem.
If the repair is not covered by the warranty, you will be notified of the charges
incurred.
If the instrument is to be returned to HANNA Instruments first obtain a
Returned Goods Authorization (RGA) number from the Technical Service
department and then send it with shipping costs prepaid.
When shipping any instrument, make sure it is properly packed for complete
protection.
Warranty
Recommendations
for Users
Before using Hanna products, make sure that they are entirely
suitable for your specific application and for the environment in
which they are used. Operation of these instruments may cause
unacceptable interferences to other electronic equipment. Take all
necessary steps to correct such interferences.
During operation, ESD wrist straps should be worn to avoid possible
damage to the electrode by electrostatic discharges.
Any variation introduced by the user to the supplied
equipment may degrade the instruments’ EMC performance.
To avoid electrical shock, do not use these instruments when volt‑
ages at the measurement surface exceed 24 Vac or 60 Vdc.
To avoid damage or burns, do not perform any measurement in
microwave ovens.
Hanna Instruments reserves the right to modify the design, construction or appearance of its products
without advance notice.
To Next Page
Loading...
Need help?
General
