DG3 Controller – Installation and Operation
Manual
540846-3 page 5 of 64 25/09/2015
Configuration options 28
3.5.3.1 Configuration code option: Time entry (TV) 28
TV = 1 (for more details, please refer to TV entry in Appendix E) 29
TV = 2 (for more details, please refer to TV entry in Appendix E) 30
TV = 3 (for more details, please refer to TV entry in Appendix E) 30
3.5.3.2 External inputs I0 and I1: emergency message, bus reversing, bus stopping,
battery guard, information message or Hanvox message 30
1) Emergency message 31
2) Blanking the sign (battery guard) 32
3) Displaying ‘Bus stopping’ 32
4) Information message 33
5) Destination VOX (Hanvox) audio message 33
6) Displaying ‘Bus reversing’ 34
System options 34
Port options 35
Sign options 35
Dump data screen sequence 35
HANCIS 36
3.5.8.1 Simulation mode 36
Setting the clock 37
3.5.9.1 How to set the date: 37
3.5.9.2 How to set the time: 38
3.5.9.3 How to set the timezone: 38
3.5.9.4 How to confirm new clock settings: 38
Reset options 39
Factory lock code reset 39
Full factory reset 39
Cold start reset 39
Firmware 40
Overview 40
DG3’s firmware version 40
Firmware update procedure 40
Overview 44
No display or backlight on controller 44
No communication or required information not displayed on signs 44
List will not load into DG3 controller 45
DG3 loads list correctly but shows 'Bad Destination or Bad Route' 45
Sign test function 45
Information code on controller screen shows ‘??’ 46
Advert code on controller screen shows ‘??’ 46
On-screen response erratic when using keypad 47
Faults not listed here 47
To Next Page
Loading...