Hansa C40 - Page 20

Hansa C40 O&M Manual – OM-013 Revision E 23/10/19
© Hansa Chippers 2019
18
Maintenance & service intervals
Maintenance interval - service hours
10 or
50 or
100
250
500 or
800
Yearly
As req.
Service
Daily
Weekly
Biannually
Engine oil change - initial change
Initial
Hydraulic oil filter - initial replacement
Initial
Belt tension – initial check
Initial
Engine oil level – check
•
Coolant level - check
•
Radiator screen – check/clean
•
Air cleaner element – clean
•
•
Bearings – grease
•
Engine engagement rod – grease
•
Outlet swivel – grease
•
Knives– check, sharpen or replace
•
•
Belt guarding – remove and clean chip build-up
•
•
Drive belts tension - check/adjust
•
Hydraulic pump belt tension - check/adjust
•
Fan belt – check
•
Engine oil & filter – change
•
Nuts & bolts – check torque
•
Tires & rims – check
•
Hydraulic system – check
•
Spring mounting – check U bolts
•
Brake fluid - check
•
Hydraulic oil filter - replace
•
Battery electrolyte level & terminals - check
•
Engine fuel filter – replace
•
Outlet chute – remove & clean swivel
•
Feed roller tension springs - replace
•
•
Anvil - check
•
•
Air cleaner element – replace
•
Hydraulic oil & filter – replace
•
Feed roller teeth – sharpen
•
•
Engine system
•
Battery – replace
•
Drive belts – replace
•
Hydraulic pump belt – replace
•
Knives – replace
•
Anvil – replace
•
Hazard labels – replace
•