Remote Control
EN
DPO7000 Quick Guide Copyright © Qingdao Hantek Electronics Co., LTD
22
8 Remote Control
The oscilloscope can be remotely controlled in the following three methods:
1. User-defined programming:
Users can program and control the oscilloscope through the standard SCPI (Standard
Commands for Programmable Instruments) command. For detailed instructions on
commands and programming, please refer to the DPO7000 Programming Manual.
2. Using IO software:
Users can use IO software to send commands for remote control of the oscilloscope. It
is recommended to use the PC software IO provided by Keysight. You can log in to the
Keysight official website (www.keysight.com) to download the software.
Operating steps:
⚫ Establish communication between the oscilloscope and the computer.
⚫ Run IO and search for oscilloscope resources.
⚫ Open the remote command control panel and send commands.
This oscilloscope can communicate with a PC through the following interfaces:
⚫ Controlled through USB
⚫ Control through LAN
⚫ Controlled through RS232/485
This chapter will provide a detailed introduction to how to use the IO software provided
by Keysight to remotely control the oscilloscope through various interfaces.
Note:
Before connecting the communication cable, please turn off the instrument to
avoid damaging its communication interface.
To Next Page
Loading...
